Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

RE: Rebar cost comparison

[Subject Prev][Subject Next][Thread Prev][Thread Next]
If you cannot find anything, to tell the truth I would assume a 20% markup 
purely for supply/demand. The cost to actually make rebar like this is not 
above that of 615. It's only that the demand is lower in comparison.

One place I've found that can serve as a good gauge for things like this is 
 DOT websites. They often have bid tabulations stretching back over the past 
 year at least. I would not use only one bid because you don’t know the 
suppositions that went into their pricing, but if you can find unit costs 
that compare favorably, use those.

-----Original Message-----
From: seaint-seaosc(--nospam--at) [mailto:seaint-seaosc(--nospam--at)] On 
Behalf Of Will Haynes Sent: Sunday, April 13, 2014 8:14 PM
To: seaint-seaosc(--nospam--at)
Subject: [SEAINT-SEAOSC] Rebar cost comparison

I am looking for a general cost difference between A615 and A706 rebar. The 
 cost comparison doesn't have to be specific to any particular U.S. location. 


Will H

Post your message to the list by sending it to: 

The email messages sent to the list will be saved in an archive on the World Wide Web.
These archives are located at:

To contact the list owner, send your message to:

Sponsored By: Pacific Structural & Forensic Engineers Group, Inc. (PSFEG)

To unsubscribe, switch to/from digest, get on/off vacation, or change your email address, click here.