Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

RE: CAD Layer Naming - Sheet Pile Wall

[Subject Prev][Subject Next][Thread Prev][Thread Next]
I was thinking maybe SB-WALL-RETW-SHTP

The first three are in the standard, I think, and the last token is custom.

-----Original Message-----
From: seaint-seaosc(--nospam--at)mail-list.com [mailto:seaint-seaosc(--nospam--at)mail-list.com] On 
Behalf Of Polhemus, William Sent: Thursday, April 24, 2014 10:28 AM
To: seaint-seaosc(--nospam--at)mail-list.com
Subject: [SEAINT-SEAOSC] CAD Layer Naming - Sheet Pile Wall

Anyone use the National CAD Standard layer naming system or similar?

If so, what do you use for a Sheet Pile wall? Structural? SB-XXXX ? Or Civil? 


Can't seem to figure out the appropriate classification.

William L. Polhemus, Jr. P.E.
Lead Civil/Structural Engineer
CRA Engineering Group, Inc.
6320 Rothway
Suite 100
Houston, TX 77040

Phone: (713) 734-3090
Direct: (832) 485-5251
Cell: (281) 450-8426
Fax: (832)485-5213
Email: wpolhemus(--nospam--at)craworld.com
http://www.craworld.com/

Truncated 500 characters in the previous message to save energy.

-------------------------------------------------------------------------
Post your message to the list by sending it to: 
   SEAINT-SEAOSC(--nospam--at)mail-list.com.

The email messages sent to the list will be saved in an archive on the World Wide Web.
These archives are located at:
    http://archive.mail-list.com/SEAINT-SEAOSC

To contact the list owner, send your message to:
   SEAINT-SEAOSC-list-owner(--nospam--at)mail-list.com.

Sponsored By: Pacific Structural & Forensic Engineers Group, Inc. (PSFEG)

To unsubscribe, switch to/from digest, get on/off vacation, or change your email address, click here.
<http://cgi.mail-list.com/u?ln=seaint-seaosc&nm=seaintma%40euken.net>