Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

Re: Square bar reinf. steel

[Subject Prev][Subject Next][Thread Prev][Thread Next]
I've assumed square bars to be true squares, so 0.56 sq in for a 3/4" sq.
bar.

On Friday, May 23, 2014, <lrhauer(--nospam--at)earthlink.net> wrote:

> Martin,
> 
> I got it! And gave it a quick look. Good info. on stresses of reinf. steel 
> back then, but nothing on bar size areas- I just hav to assume that a
> square
> bar that is called out as 3/4" sq. will be an areof .75x.75 or 0.56 in.
> sq., not what a round #6 is or 0.44 sq. in.
> 
> Any last thoughts?
> 
> Thanks again,
> 
> Larry Hauer, S.E.
> 
> -----Original Message-----
>> From: Martin Li <zmli(--nospam--at)hotmail.com <javascript:;>>
>> Sent: May 22, 2014 9:36 PM
>> To: seaint-seaosc(--nospam--at)mail-list.com <javascript:;>
>> Subject: RE: [SEAINT-SEAOSC] Square bar reinf. steel
>> 

Truncated 870 characters in the previous message to save energy.

--
David Topete, SE

-------------------------------------------------------------------------
Post your message to the list by sending it to: 
   SEAINT-SEAOSC(--nospam--at)mail-list.com.

The email messages sent to the list will be saved in an archive on the World Wide Web.
These archives are located at:
    http://archive.mail-list.com/SEAINT-SEAOSC

To contact the list owner, send your message to:
   SEAINT-SEAOSC-list-owner(--nospam--at)mail-list.com.

Sponsored By: Pacific Structural & Forensic Engineers Group, Inc. (PSFEG)

To unsubscribe, switch to/from digest, get on/off vacation, or change your email address, click here.
<http://cgi.mail-list.com/u?ln=seaint-seaosc&nm=seaintma%40euken.net>