Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

Re: Form board trench drain in existing floor slab

[Subject Prev][Subject Next][Thread Prev][Thread Next]
You might look at Azek trim (a little thicker) or HardiBoard siding (a little thinner).
Chuck Utzman, PE

On 9/19/2014 6:28 PM, Drew Morris wrote:
Sounds good. Looking for 1/2" or so wall thickness, any generic product spring to mind?

On 9/19/2014 4:49 PM, Himanshu Goyal wrote:
Plastic ?

On Friday, September 19, 2014, Drew Morris <dmorris(--nospam--at)bbfm.com> wrote:

I need to add a trench drain to an existing concrete fill on metal floor
deck system.  The drains will be sandwiched in between two W12 beams.
Resting on the top of the bottom flanges will be a section of steel floor deck. Surrounding the drain on the sides and bottom, there will be form boards that will be left in place. I am looking for a material that can
remain behind and not degrade.  Any suggestions?
--
*
Drew Morris, PE*| Project Engineer

Truncated 422 characters in the previous message to save energy.

---
This email is free from viruses and malware because avast! Antivirus protection is active. http://www.avast.com

-------------------------------------------------------------------------
Post your message to the list by sending it to: SEAINT-SEAOSC(--nospam--at)mail-list.com.

The email messages sent to the list will be saved in an archive on the World Wide Web.
These archives are located at:
   http://archive.mail-list.com/SEAINT-SEAOSC

To contact the list owner, send your message to:
  SEAINT-SEAOSC-list-owner(--nospam--at)mail-list.com.

Sponsored By: Pacific Structural & Forensic Engineers Group, Inc. (PSFEG)

To unsubscribe, switch to/from digest, get on/off vacation, or change your email address, click here.
<http://cgi.mail-list.com/u?ln=seaint-seaosc&nm=seaintma%40euken.net>