Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

Re: Common column with braces

[Subject Prev][Subject Next][Thread Prev][Thread Next]
Thank you, Gary. I'll do some searching.

On Wednesday, May 20, 2015, Gary L. Hodgson and Assoc. <design(--nospam--at)hodgsoneng.ca> 
 wrote:

> David,
> There are some design examples out there where short lengths of Tees cut
> from the same shape as the column are welded into the column to create a
> cruciform section locally.  I would have to do some searching but if you
> can't find anything, I will descend to the depths of my basement to look
> for references.
> Gary
> 
> On 5/19/2015 3:12 PM, David Topete wrote:
> 
>> I assume that BRB braces have been successfully installed from two
>> directions into a common wide flange column section. And, without the
>> need of fabricating a cruciform column shape.
>> 
>> Any thoughts on this? Thanks.
>> 
>> --
>> David Topete, SE

--
David Topete, SE

-------------------------------------------------------------------------
Post your message to the list by sending it to: 
   SEAINT-SEAOSC(--nospam--at)mail-list.com.

The email messages sent to the list will be saved in an archive on the World Wide Web.
These archives are located at:
    http://archive.mail-list.com/SEAINT-SEAOSC

To contact the list owner, send your message to:
   SEAINT-SEAOSC-list-owner(--nospam--at)mail-list.com.

Sponsored By: Pacific Structural & Forensic Engineers Group, Inc. (PSFEG)

To unsubscribe, switch to/from digest, get on/off vacation, or change your email address, click here.
<http://cgi.mail-list.com/u?ln=seaint-seaosc&nm=seaintma%40euken.net>